Download Roll Call Connect Administration Guide

Transcript
If you have successfully followed these steps, you have finished the pre-installation steps. The
next section will outline the steps for installing and configuring Apache Web Server and Roll Call
Connect.
Install and start Apache Web Server
The Apache web server will be used to process incoming web traffic for Roll Call Connect and
forward that traffic to Roll Call’s integrated web server. Below are the directions for installing the
default setup for Apache web server. A later section will walk you through modifying the initial
setup for use with Roll Call Connect.
Mac OSX
If you are using a Mac – good news! It comes pre-installed with Apache. All you need to do is
turn it on. To turn on the default installation of Apache, open a Terminal window and type: sudo
apachectl start
That’s it! Open a browser on the computer and type localhost. You should see the response of It
Works!
To stop Apache type: sudo apachectl stop
Automatically Starting Apache on MacOS
To automatically start Apache on a MacOS environment go to the terminal and type the
following:
sudo launchctl load -w /System/Library/LaunchDaemons/org.apache.httpd.plist
Windows OS
You can find and install Apache from your own source or you can follow the steps below. At the
time of writing this document, the current version of Apache was 2.4.12.
•
•
•
•
•
Open up Browser and go to http://www.apachelounge.com/download/.
Verify that you have Microsoft Visual C++ Redistributable for Visual Studio 2012 installed
on your computer. If not then click the link to install.
Download Apache Win32 or Win64 depending on your OS.
Unzip download and open the included Readme. Follow the directions to install Apache and
ApacheMonitor. Directions are also included on how to start Apache. Make sure in the DOS
window to change directory to C:\Apache24\bin. Make sure to add Apache as a service and
start Apache.
Set up Apache to run as a Windows Service. This will automatically start Apache when the
machine starts and stop it when the machine is shut down. From a DOS prompt go to the
Apache24/bin folder.
To add Apache Service - httpd.exe –k install
To remove Apache Service - httpd.exe –k uninstall
7