Download Type 2250 Product Sheet

APPENDIX A
Setup Parameters
Table A.9
(Cont.) Measurement Control parameters – for BZ-7222 to BZ-7225
Parameter
Fourth Check
b
Values
00:00:00 to
23:59:59
Comment
Set time of day for fourth CIC check
Note: The Check times must be separated from
each other by at least one minute. They should also
differ by at least one minute from the time set in the
Save Project Data at parameter
a. For Sound Level Meter (BZ-7222) and Frequency Analyzer (BZ-7223) templates only.
b. For Enhanced Logging (BZ-7225) templates only.
c. For Logging (BZ-7224) and Enhanced Logging (BZ-7225) templates only.
A.9
Measurement Control – for Reverberation Time
Software BZ-7227
Table A.10
Measurement Control parameters – for Reverberation Time Software BZ-7227
Parameter
Values
Comment
Map Based Measurement
No
Yes
If Map Based Measurement = Yes you can define
the source positions and receiver positions
graphically on a map – otherwise the
measurements are just numbered from position
number one (Pos. 1) onwards
Meas. All Pos. for Each
Source
No
Yes
Parameter only available if Map Based
Measurement = Yes.
Set to Yes for measuring all positions for each
source position.
Set to No for measuring a specific number of
receiver positions per source position
No. of Positions per Source
1 to 10
Parameter only available if Meas. All Pos. for
Each Source = No
Set number of receiver positions you want to
measure per source
Increment
Sources First
Receivers First
Manual
Parameter only available if Map Based
Measurement = Yes.
Allows you to select the quickest method of
measurement, when positioning your analyzer in
relation to source and receiver positions.
(Typically, Sources First is best for Impulsive
Excitation and Receivers First is best for
Interrupted Noise excitation)
Automatic Save
No
Yes
Set to Yes to automatically save the decay after
each measurement
195