Download microSTATION Operation guide

Appendix
Error messages
Various messages
F
File exists
A
Meaning: When executing a file rename command, an identically‐named file existed on the media.
Access denied
Action: Delete the existing file, or specify a different name.
Meaning: This will appear if you attempt to execute the song command “Memory Status” while playing or recording on the sequencer.
Action: Stop the sequencer before you execute the song command “Memory Status.”
File invalid
Meaning: You attempted to load or open a file whose file format was incorrect.
File not found
C
Meaning: When performing a file delete command, the specified file did not exist.
Can’t calibrate
Action: Check the media or file.
Meaning: Calibration could not be performed correctly.
File read only
Action: Try the operation again.
Meaning: You attempted to delete a file, but that file had a read‐only attribute.
Can’t undo
Meaning: Free memory for undoing (the Compare function) could not be allocated when you finished recording in Sequencer mode, or when you executed an edit. The data you just recorded or edited will remain, but undo (Compare) cannot be executed.
Action: In order to allocate sufficient free memory for undo (Compare) to be available, you can delete unneeded song or track data. We recommend that you save your data to media before executing.
Completed
Meaning: The command was executed, and completed Action: The command you executed was successful.
Meaning: You attempted to save a file using the same name as a read‐only file that already existed on the media.
Action: Save the file under a different name.
Format failed
Meaning: An error occurred while formatting media.
Action: Use different media.
FX size mismatch
Meaning: When copying or swapping effects, you attempted to place a double‐size effect at IFX5 (insert effect 5) or MFX2 (master effect 2).
Action: Don’t specify a double‐size effect for IFX5 or MFX2 when executing the command.
FX type mismatch
D
DestMeasureEmpty
Meaning: There is no data in the specified measure.
Action: Specify a measure that contains data.
Dest same as src
Meaning: When copying, you selected the same song or track as the copy‐source and copy‐destination.
Action: Make sure that the copy‐source and copy‐
destination are different songs or tracks.
Dest. empty
Meaning: When editing, the track you specified contains no performance data.
Action: Specify a track that contains performance data.
Dest. song empty
Meaning: The song you specified as the copy‐
destination does not exist.
Action: Before you copy, execute the song command “Create New” to create a song.
68
Meaning: This message will appear when copying or swapping effects if the copy‐destination or swap‐destination IFX (insert effect), MFX (master effect), or TFX (total effect) has an effect that cannot be selected.
Action: For each IFX, MFX, and TFX, some effects can be selected and other effects cannot be selected. Verify that the effect is one that can be selected for the copy‐destination or swap‐destination IFX, MFX, or TFX.
I
Illegal name
Meaning: An invalid file name was specified.
Action: Change the file name. You may not specify a file name that is invalid in MS‐DOS.