Download Web Performance Load Tester 3.6 manual

These parameters will create a rule that is very similar to the rule created in the previous step. The primary
difference is that instead of only employing this rule for a specific field name, it will apply the rule for any field
for which it cannot find a match using the default rules. In addition, the name of the field will be dynamically
inserted into the detection prefix and suffix so that the detection parameters can be specific as possible to
avoid false positives. The field name will be substituted into the prefix and/or suffix in place of the {0} character sequence. Any places in the testcase where a match is found, the ASM wizard will automatically configure the extractor and modifier as demonstrated above.
Unlike a single field configuration, the single quote character is reserved as an escape sequence. To force
the detector to match a brace (such as { ), the brace may be surrounded by single quotes. If the detector
should match a single quote, then the quote should be doubled.
Press the Test selected Rule(s) button to validate the configuration. Note that this step verifies that the configuration is valid but not necessarily correct. In other words, it checks that the combination of parameters provided is allowed and the parameter names are spelled correctly, but cannot verify that the rule have the
intended result.