Download FS4430 DP State Analysis Preprocessor User Manual

Transcript
Dynamic Lane width
tracking
The FS4430 can maintain lock and processing on a DP link as it changes lane width.
Because a reset to the preprocessor’s serdes would result in the loss of lane data, the
serdes is not reset when lane width changes. For this reason we recommend that the
FS4430 be set in the Probe Manager to the maximum lane width at the start. As the
lane width decreases the user will notice that the Signal LED goes dark, but the Data
LED stays green. This is acceptable as it is just an indication that the serdes has lost
signal on the lanes no longer operating. Also, the error log will show errors on the lanes
that are no longer in operation.
You can stop the probe, reconfigure the lane width, and then restart the probe. This will
set-up the serdes properly for that new lane width and all the LEDs and Error Log
should operate properly at that new lane width.
21