Download Hardware User`s Manual Avoidance programmer with shocker

Transcript
8.2. LE 2708 REAR PANEL
TRIALS START CONTROL
+5V
GND
DIODES
REMOTE RESPONSE SOUND DOOR SHOCK
START
LIGHT CAGE
RS-232
POWER
Figure 9. LE 2708 Rear Panel.
A TTL pulse is a pulse of 5V logic. The female connectors on the rear panel must be
activated with 5V signals and the outputs give 5V signals.
•
+5V: There is +5V at this point.
•
GND: There is Ground at this point.
•
TRIALS: Each TTL pulse here (+5V level) increases the TRIAL counter in the
display by one unit. When the TRIAL number reaches the value selected in
Timer T, the sequence stops if the switch is in ACTIVE TRIALS.
•
START CONTROL: Gives a TTL signal when the START button on the front
panel is pressed (ACTIVE MODE). Or gives a TTL pulse after Timer T ends
(PASSIVE mode).
•
REMOTE START: The program can be activated by pressing a foot switch
connected to this point. It has the same function as the START button on the
front panel.
•
LIGHT: Activates the light in the cage when available.
•
SOUND: Activates the sound in the cage when available.
Avoidance programmer with shocker
14