1
Download downloaded - i
Transcript
REFERENCES 5 5.12 DEFAULT PARAMETERS FOR POS TERMINALS The default values of the RS232 and Data Format parameters for POS terminals are listed in the following table: NIXDORF Mode A FUJITSU ICL Mode 9600 Odd 8 1 Hardware (RTS/CTS) Disabled Disabled Disabled 9.9 sec Disabled 9600 None 8 1 None Disabled Enabled Disabled 2 sec Disabled 9600 Even 8 1 RTS always ON Disabled Enabled Disabled 9.9 sec Disabled Custom No Header CR Disabled Not Transmitted Disabled Disabled Disabled Custom No Header CR Disabled Not Transmitted Disabled Disabled Disabled Custom No Header CR Disabled Not Transmitted Disabled Disabled Disabled RS232 Group Baud Rate Parity Data Bits Stop Bits Handshaking ACK/NACK Protocol FIFO Inter-Character Delay RX Timeout Serial Trigger Lock Data Format Group Code Identifier Header Terminator Field Adjustment Code Length TX Character Replacement Address Stamping Address Delimiter The table below lists all the Code Identifiers available for the POS terminals: CODE UPC-A UPC-E EAN-8 EAN-13 Code 39 Codabar Code 128 Interleaved 2 of 5 Code 93 Industrial 2 of 5 UCC/EAN 128 MSI/Plessey RSS PDF417 Other NIXDORF Mode A A0 C0 B A M N K I L H P O E Q None FUJITSU A E FF F None None None None None None None None None None None ICL Mode A E FF F C [code length] N [code length] L [code length] I [code length] None H [code length] L [code length] None None None None 149
