Download OPERATIONS MANUAL - Control Laser Corporation

When the line object is drawn for the first time, default lasing parameters are assigned
to it. Change the defaults by typing in the parameters to use as defaults in the
parameter section and press the Save as Defaults located just below the lasing
parameters section.
This sets the default parameters as the ones you have just entered in the lasing
parameter list. Each time you draw a line tool object, it will have these new parameters
assigned by default.
E. Cut / Run
Once the lasing parameters for the line object are set, begin the cross sectioning
process by pressing the Run button as shown below. This cuts the chip along the line
drawn.
Press Run to begin cross sectioning process
F. Saving and Loading
To save the line tool object and lasing parameters in a single Job file, click on File from
the main menu and select Save. Job files are saved with the .JOB extension.
To load any saved job file, click on File from the main menu and select Load.
6.2.4 General Parameters
Caption
Provides the name of the lasing object. This is a read
only value.
6.2.5 Geometry Parameters
Start X
Starting X coordinate of the line in the laser's lasing
field.
FALIT™ – Laser Operation Manual | 56
Copyright © 2015 Control Laser Corporation