Download User Manual

CHAPTER 2
Setup and Configuration
Mounting the Fixture
You can mount your SHOWBEAM 2.5 fixture suspended from a support system (such as a truss)
or freestanding on its base.
WARNING!
Equipment suitable for dry locations only. Do not expose this
equipment to rain or moisture.
CAUTION!
SHOWBEAM 2.5 fixtures must be installed and operated by trained
personnel only.
Always use a secondary safety cable when mounting this fixture.
Do not mount on a flammable surface or within 1 m (3 ft) of a
flammable object.
Maintain a minimum focus distance of 4 m (13.1 ft) from any flammable
object.
3
Note:
Maintain a minimum focus distance to non-flammable lighted object of
3 m (9.8 ft)
Due to the wide variety of possible lighting designs, High End
Systems cannot make specific mounting recommendations. Consider
the following procedure as a suggested guideline only.
Mounting the Fixture Upright
CAUTION!
Do not mount the fixture upright without the four rubber feet
attached.
To mount the fixture upright:
1. Place the fixture on a sturdy, stable non-flammable surface that will support more than the
63.5 kg (140 lb) weight of the SHOWBEAM 2.5 fixture. If the surface is above floor height,
use safety cables to secure the fixture to the surface.
2. Disengage Pan and Tilt locks before powering up the fixture.
SHOWBEAMTM2.5 User Manual
9