Download FDC 1.2 - The UK Mirror Service

Transcript
Fwind = [ Xw Yw Zw ]T
corrections to body-axes forces in non-steady atmosphere, Fwind
T
yatm
= [ ρ ps T µ g ]
basic atmospheric properties, yatm
yad1
= [ a M qdyn ]T
basic airdata variables, yad1
yad2
yad3
T
= [ qc V e V c ]
additional airdata (-related) variables, yad2
T
= [ Tt R e R c ]
additional airdata (-related) variables, yad3
Parameters
The subsystems from Level 2 require the variables AM , EM , GM1 , GM2 , xfix , and xinco to be defined
in the Matlab workspace. The following list shows which variables are needed by which (masked or
non-masked) subsystem from Level 2:
AM:
EM:
GM1:
GM2:
xfix:
xinco:
Aerodynamics Group (Beaver),Aircraft Equations of Motion (Beaver)
Engine Group (Beaver)
Additional Outputs, Aerodynamics Group (Beaver), Aircraft Equations of Motion (Beaver),
Airdata Group, Engine Group (Beaver), Fwind, Gravity
Aircraft Equations of Motion (Beaver)
Aircraft Equations of Motion (Beaver)
Additional Outputs, Aircraft Equations of Motion (Beaver)
The variables AM , EM , GM1 , and GM2 can be defined by the routine MODBUILD (section 9.2) or
retrieved from file by LOADER (section 9.3.1). The variable xfix can be used to fix state variables
artificially to their initial values. It is defined by LOADER and can be altered by FIXSTATE (section 9.5)
if required. The initial value of the state vector is obtained from xinco, which can be computed with
the trim routine ACTRIM (section 8.2), or loaded from file with INCOLOAD (section 9.3.2).
Connections
in: all input vectors are obtained from Level 1 by means of Inport blocks in Level 2
out: all output vectors from the aircraft model (except for some very trivial results such as the help
vector yhlp are sent to Level 1 by means of standard Outport blocks
Enter type level2.hlp at the command-line for on-line help.
99
2