Download E5CN Temperature Controller

Appendix A
Power ON
key Less than 1 second
Operation level
Adjustment level
key Less than 1 second
Add in the additional PV
display" parameter.
PV
AT execute/cancel
Auto-tuning
PV/SP
Communications writing
Enable or disable writing by communications.
Multi-SP
Select SP.
Heater current
value monitor
SP ramp monitor
Heater burnout
detection
Heater current value monitor
Current value monitor of HBA
SP 0
Run/stop
SP 1
Alarm value 1
SP 2
HBA function
SP used by multi-SP
Upper-limit
alarm value 1
Set either of these parameters.
SP 3
1-point shift
Lower-limit
alarm value 1
Temperature input
shift
Alarm value 2
Upper-limit temperature input shift value
2-point shift
Upper-limit
alarm value 2
Set either of these parameters.
Lower-limit temperature input shift value
Lower-limit
alarm value 2
Proportional band
P
MV monitor (OUT1)
Integral time
I
MV monitor (OUT2)
Derivative time
D
Cooling
coefficient
+
key
1 second min.
+
key
3* second min.
* The key pressing time can
be changed in "protect level
move time".
Protect level
Operation/adjustment protection
Restricts display and modification of menus in
the operation and adjustment levels.
Initial setting/communications protection
Restricts display and modification of menus in the initial setup, operation level and adjustment levels.
PID settings
Used in heating and cooling control
Dead band
Manual reset value
Clear the offset during stabilization of P or PD control.
Hysteresis (OUT1)
Set hysteresis.
Hysteresis (OUT2)
Setting change protection
Protects changes to setups by operation of the
front panel keys.
131