Download TOMLAB /MINLP manual - TOMLAB Optimization

Transcript
Prob, The following fields are used:, continued
istat
Similarly, for warmstarts, set istat to Result.DUNDEE.istat from the previous
run. Only the first element is used.
lam
Vector of initial multipliers. Necessary for warmstarts, but can always be given
if desired. Must be n+m elements in order to be used.
morereal
Increase of REAL workspace. A problem dependent default value is used if <0
or empty.
moreint
Increase of INTEGER workspace. A problem dependent default value is used
if <0 or empty.
Scaling parameters: It is possible to supply scale factors for the variables and/or
the constraints. Normally, the DUNDEE solvers does not differentiate between
linear and nonlinear constraints with regard to scaling, but the Tomlab interface
handles this automatically. Thus is it possible to give scale factors e.g. for the
nonlinear constraints only. All scaling values must be greater than zero.
xScale
Vector of scale factors for variables. If less than n values given, 1’s are used for
the missing elements.
bScale
Vector of scale factors for the linear constraints. If length(bScale) is less than
the number of linear constraints ( size(Prob.A,1) ), 1’s are used for the missing
elements.
cScale
Vector of scale factors for the nonlinear constraints. If length(cScale) is less
than the number of nonlinear constraints, 1’s are used for the missing elements.
Description of Outputs
Result, The following fields are used:
Result
fk
gk
The structure with results (see ResultDef.m).
Function value at optimum.
Gradient of the function.
xk
x0
Solution vector.
Initial solution vector.
ck
cJac
Nonlinear constraint residuals.
Nonlinear constraint gradients.
xState
State of variables. Free == 0; On lower == 1; On upper == 2; Fixed == 3;
21