Download Model 2002 Multimeter User`s Manual

Transcript
Example Programs
Measure High Speed Channels;
Model 2001-SCAN
• Model 2001-SCAN Scanner Card (installed in the
Model 2002)
• Microsoft QuickBASIC 4.5
Microsoft QuickBASIC 4.5
Keithley KPC-488.2 Interface
• Any one of the following IEEE-488 interfaces:
Keithley Model KPC-488.2
Keithley Model KPC-488.2AT
Capital Equipment Corporation PC<>488
©1992, Keithley Instruments, Inc.
The program assumes that the Model 2002 is set to address
16.
Description
This program measures (DCV) the two high speed channels
(ch 5 and 10) of the Model 2001-SCAN Scanner Card. Each
channel is measured five times for a total of 10 measurements. The DCV reading and the elapsed time for each measurement are displayed on the computer CRT.
Required equipment
Loading user library
The user library for QuickBASIC 4.5 is provided with the
IEEE-488 interface (ieeeqb.qlb). Assuming QuickBASIC
and the user library are in the same DOS directory, enter the
following command line from the DOS prompt:
QB /L ieeeqb.qlb
• Model 2002 Multimeter
The above command line will load QuickBASIC and the
user library.
Program (scan2001.bas)
'$INCLUDE: 'ieeeqb.bi'
CLS
CALL initialize(21, 0)
DIM k2002data AS STRING * 20
CALL send(16, "*RST; :init:cont off; :abor", gpib.status%)
' Disable continuous initiation
' and put 2002 in idle.
CALL send(16, ":trig:sour bus; coun 10", gpib.status%)
' Set trigger layer source to BUS
' and count to 10.
CALL send(16, ":sens:func 'Volt:DC'", gpib.status%)
' Select DCV function
CALL send(16, ":sens:volt:dc:nplc .01", gpib.status%)
' Set reading rate to 0.01 nplc
CALL send(16, ":form:elem read,chan", gpib.status%)
' Include reading and channel
' number in data string
CALL send(16, ":sens:volt:dc:aver:stat 0", gpib.status%)
CALL send(16, ":init:cont on", gpib.statsu%)
G-14
' Disable filter
' Take 2002 out of idle
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com