Download Operation Manual

Transcript
UTILITY STITCHES ——————————————————————————————————————————————————
The names of parts of buttonhole foot “A”, which is
used for sewing buttonholes, are indicated below.
1
■ If the button does not fit in the button guide
plate
Add together the diameter and thickness of
the button, and then set the button guide
plate to the calculated length. (The distance
between the markings on the presser foot
scale is 5 mm (3/16 inch).)
2
1
5
3
2
4
3
A
a
b
c
d
e
a Presser foot scale
b Length of buttonhole
(Diameter + thickness of button)
c 5 mm (3/16 inch)
Button guide plate
Presser foot scale
Pin
Marks on buttonhole foot
5 mm (3/16 inch)
Use chalk to mark the position and length of
a the buttonhole on the fabric.
Example: For a button with a diameter of 15 mm
(9/16 inch) and a thickness of 10 mm (3/8 inch),
the button guide plate should be set to 25 mm
(1 inch) on the scale.
1
1
2
a 10 mm (3/8 inch)
b 15 mm (9/16 inch)
a Marks on fabric
Pull out the button guide plate of buttonhole
b foot “A”, and then insert the button that will
A
be put through the buttonhole.
c
Attach buttonhole foot “A”.
d
Select a stitch.
e buttonhole mark aligned with the red marks
Position the fabric with the front end of the
on the sides of the buttonhole foot, and then
lower the presser foot lever.
Pass the upper thread down through the hole
in the presser foot.
1
2
X The size of the buttonhole is set.
2
A
a Mark on fabric
b Red marks on buttonhole foot
36