Download 3.8 MB - Juniper Networks
Transcript
Connectivity Failover Another method of achieving reliability is through the use of “Connectivity Failover”. Connectivity failover (also known as “Gateway Failover”) allows you to initiate failover in the active-standby topology by doing health checks on pre-configured hosts (ActiveN is supported). You must first set up a DX appliance in an active-standby topology. You then configure a group of IP addresses to health check; these IP addresses will be checked for layer 3 connectivity. If a health check fails, the standby DX appliance will take over as the primary. WARNING: Enabling this feature and having a failover event causes the DX appliance to reboot. WARNING: Be certain that the hosts you choose to health check are pingable when you add them into your health checking. If they are not, then the following occurs: Assume that DX appliance A is the active unit and DX appliance B is the standby unit. If you add the IP of a host that is down to remote host health checking, DX appliance A will not be able to ping that host, and will eventually failover to DX appliance B. This causes a reboot of DX appliance A. Depending upon the configuration of DX appliance B, it is possible that DX appliance A will not be done rebooting by the time DX appliance B reboots. This can cause significant problems. The “Server Load Balancer” (SLB) can also be included in the failover (you must enable SLB failover). The configured IP addresses are checked for Layer 3 connectivity via a ping; no Layer 4 check is performed. If a configured number of health checks fail, the active DX appliance is switched to Standby mode. This allows the other DX appliance to become active. To enable connectivity failover, you must enable failover with set server failover enabled. The following items must be configured: The health check interval (default value is 10 seconds; range: 10-600 seconds). The timeout value waiting for a response (default value: 10 seconds; range: 1-60 seconds). The maximum health check attempts per host (default value is 5; range: 1-60). The minimum remote hosts failing before activating failover (default value is 1; range: 1-10). The hosts to health check (maximum: 10). Connectivity failover enabled/disabled (default value is disabled). The DX appliance will add an entry to the system logs when failover occurs. If the “timeout value” is larger than the “health check interval,” and a remote host is not responding, a health check request will not be sent until the “timeout value'” has expired. In other words, if a host is not responding, the health check interval becomes the maximum value of the interval and timeout. Connectivity Failover 131