Download User`s Manual

b) Drill two holes (3.5mm diameter) on the tub with approximate distance as shown
in Fig. 2b below. Insert the electrodes and tighten the nuts to secure the ring
connectors as shown in Fig. 2a below.
c) Connect the other end of sensor cable to the control box port named “Level
Sensor”
Electrode 1
23in (max)
23in (Max)
Electrode 1
Electrode 2
Electrode 2
Horizontal Configuration
Vertical Configuration
a)
b)
Fig. 2: a) Electrode mounting behind the tub
b) Electrode Configurations
1
2
Fig. 3: Keypad with temperature sensor and RJ25 cable connected
1
RJ25 Cable
2
Temperature Probe
Connect one end to the back of keypad and the other end to the ‘button’
port of control box.
Connect the square female end of the probe to the male end of the
keypad. Drop the probe on water.