Download Z88 USER - Virtual TR-DOS
Transcript
10 FOR a =7 TO 12 20 PRINT a ; 30 IF a < 10 THEN PRINT " This is young enough"; 40 IF a > 9 THEN PRINT " This is too old"; 50 PRINT 60 NEXT a Incidentally, did you notice that the printouts were not aligned vertically? This is because 7,8,9 are single digits but 10,11 and 12 have double digits. This can easily be corrected by using the TAB function. Change line 20 to read: 20 PRINT a; TAB 3; Now, let us play Guess the number game (for 2 players)10 REM Guess the number 20 INPUT "Enter a number", a : CLS 30 INPUT "Guess the number", b 40 IF b = a THEN PRINT "That is correct ": STOP 50 IF b < a THEN PRINT "That is too small,try again" 60 IF b > a THEN PRINT "That is too big, try again" 70 GOTO 30 Note. CLS in line 20 clears the screen to prevent the other person from seeing the secret number. 'IF....THEN may used with other instructions other than PRINT, and one of the most common uses is to make an Unconditional Jump to another line, an example of which is shown below: 10 REM Count to seven 20 LET counter = 1 30 PRINT counter 40 Let counter = counter + 1 50 IF counter <= 7 THEN GOTO 30 MORE DECISIONS There is a feature of Spectrum BASIC, which not all computers have. There are the special expressions known as logical operators. These are OR, AND, NOT. From these we get a result which is once again TRUE or FALSE; for example in 30 IF i < 10 OR j >20 THEN GO TO 66 The meaning of OR is something OR something is TRUE if either of the somethings are TRUE. This includes the case where both somethings are TRUE. When the AND operator is used, this means something AND something is TRUE only when both somethings are TRUE. Finally, when the NOT operator is used, this means NOT something is TRUE when the something is FALSE and vice versa I hope that this doesn't sound too much like Double-Dutch, but I believe that if you think about it carefully it will become clear to you. A good example of AND, NOT and OR can be found with the program MAKE A CHIP. A truth table is a helpful thing to explain this more clearly. If we set Logic 1 = TRUE and logic 0 = FALSE then we get the following relationships: OR FUNCTION AND FUNCTION NOT FUNCTION 0 OR O = 0 0 AND 0 NOT 0 = 1 1 OR 0 = 1 1 AND 0 NOT 1 = 0 0 OR 1 = 1 0 AND 1 = 0 1 OR 1 = 1 1 AND 1 = 1 KB. = 0 = 0