Download R&S AMU200A Operating Manual

R&S®AMU200A
Remote Control Commands
SOURce Subsystem
[:SOURce<hw>]:IQ:OUTPut:DIGital:STATe <State>
This command switches on and off the digital I/Q output signals.
Parameters:
<State>
0 | 1 | OFF | ON
*RST:
0
Example:
IQ:OUTP:DIG:STAT ON
the digital I/Q output signals of path A are activated.
Options:
B13 and B18
7.14.6 SOURce:PATH Subsystem
This subsystem contains the command for retrieving the number of installed RF paths.
7.14.7 SOURce:ROSCillator Subsystem
This subsystem contains the commands for setting the external and internal reference
frequency.
The commands of this subsystem are not affected by an instrument reset (​*RST​
on page 398).
[:​SOURce]:​ROSCillator:​EXTernal:​FREQuency​..................................................................601
[:​SOURce]:​ROSCillator[:​INTernal]:​ADJust:​VALue​..............................................................602
[:​SOURce]:​ROSCillator[:​INTernal]:​ADJust[:​STATe]​............................................................602
[:​SOURce]:​ROSCillator:​SOURce​.....................................................................................602
[:SOURce]:ROSCillator:EXTernal:FREQuency <Frequency>
The command informs the instrument of the frequency of the external reference.
Parameters:
<Frequency>
5MHz | 10MHz
Default unit: Hz
Example:
ROSC:SOUR EXT
selects the external source. The reference must be input at the
REF IN input.
ROSC:EXT:FREQ 5MHz
informs the instrument that the external reference frequency is
5MHz.
Usage:
SCPI confirmed
Operating Manual 1402.5222.32 ─ 09
601