Download CS User Manual

Transcript
U|g|CS User manual, v.2.1
Route Parameters
The third step is to review and set missing parameters of the route. In order to ensure a safe execution of
the mission, it is crucial to understand and review all of the parameters before the route is confirmed.
Figure 10. The third step of the route creation wizard.
Home location is a point to which the vehicle should return in the case of a failsafe condition being triggered
automatically or the operator giving the command to return home. Failsafe execution conditions usually
include emergency situations such as loss of RC or low battery charge level.
The home position can be set explicitly, or the first waypoint of the route can be set as the home location
(Figure 10, a). If it is set explicitly, the coordinates can be specified in numerical form; either decimal or
degrees-minutes-seconds (DMS) formats can be used.
Note: To switch to the decimal degrees format, click on the
click on the
button.
button. To switch back to the DMS format,
An alternative and usually more convenient way to set the home position is to point it on the map. Click the
button with the crosshair icon (Figure 10, b) to use this option. As soon as the map is loaded, the location
can be defined by dragging with left mouse button while holding the “Shift” key. A pin will appear and
change its height depending on the position of the mouse pointer (Figure 11). After the location has been
chosen, clicking on the OK button takes you back to the wizard.
13