Download Target System Specifications:

2.3
2.4
2.5
2.6
2.7
2.8
2.9
2.10
2.11
The manufacturer will provide all materials needed for the installation,
operation, and set up of the target system. Client provided materials,
equipment, devices, or services required for the installation must be
specified in the response.
The manufacturer will provide training to the client and any designees in
the recommended and safe operation of the target system. This training
will also include any required user routine maintenance, and
troubleshooting. The manufacturer will provide a user manual for the
target system that supports the on site training provided by the
manufacturer.
The manufacturer will provide certifications to support any claims of
armor strength or bullet resistance.
The manufacturer will construct and install the target system in
accordance with acceptable construction and installation standards.
The manufacturer will warrant the target system against defects in
workmanship, materials, and installation for a minimum of five years.
This warranty will not include coverage of damage or system failure due
to improper, or misuse of the target system in violation of the
manufacturer’s user manual or provided training. This warranty will be
provided in writing and will bear the manufacturer’s signature, or that of
an authorized representative.
The manufacturer, if awarded the contract, will provide start and finish
dates for the installation of the target system. The manufacturer will remit
one percent of the total contract cost to the client for each day past the
accepted completion date the project remains unfinished. Delays for
weather will not count against the accepted finish date.
Change orders require written notification by the manufacturer and/or
client. Acceptance of any change orders must bear the signature of the
manufacture and client or their representatives.
Installation space for the system is 130 linear feet. The manufacture will
specify the number of target holders/actuators that can be accommodate in
this space.
Walk through inspections of the client’s installation site may be arranged
by appointment.
3.0
3.1
3.2
3.3
Target System Specifications – Target Holder
The target holder frames shall be constructed to hold a wooden framed,
cardboard backed standard pistol qualifications target.
The target holder will be equipped with a clamp mechanism to hold a 2x2,
or 1x2 lumber target frame. The clamp mechanism will require no tools
and will be hand tightened.
The clamp mechanism will be sufficient to hold the wooden target frame
in place while the while the target holder is in motion. It will also be