Download N30 Supervisory Controller Point Mapping Technical Bulletin

N30 Supervisory Controller Point Mapping
3
N30 Supervisory Controller Point
Mapping
Introduction
The N30 Supervisory Controller (referred to as N30 throughout this
document) provides supervisory functions to intelligent controllers.
The controllers have a number of points and internal parameters,
which are used to store input data and control hardware (for example,
temperature sensors and fan controls). This document assumes that
you are manually entering points using a VT100 Terminal or
VT100 Terminal Emulator. This document contains:
•
considerations when mapping points in an N30 database
•
where to get configuration printouts for controllers
This document also describes how to:
•
read configuration printouts for Air Handling Unit (AHU),
Unitary (UNT) Controller, Variable Air Volume (VAV) Controller,
Phoenix Interface Module (PHX), and TC-9100 controllers
•
read Lab and Central Plant Controller (LCP/DC9100) and
DX-9100 configuration printouts
•
add controllers to an N30 database with Project Builder
•
add controllers to an N30 database with a VT100
•
map controller points to N30 objects with Project Builder
•
map controller points to N30 objects with a VT100
This document also contains point mapping tables to map controller
points to the N30 database.
Note:
Unless otherwise indicated, the information in this document
also applies to the N31 Supervisory Controller.