Download User Manual

AC1600 WiFi VDSL/ADSL Modem Router Model D6400
11. Enter the cable or fiber settings as described in the following table.
Field
Description
Transfer Mode
DSL Mode
Multiplexing Method
VPI
Unless you changed the physical WAN interface settings so that the
modem router must use the Ethernet WAN interface (see Change the
Physical WAN Connection Preference on page 194) these settings are not
disabled. However, these settings do not apply to a cable or fiber
connection and you can ignore them.
VCI
Use VLANID
Select the Use VLANID check box and enter the VLAN ID, as indicated by
your ISP.
A VLAN ID might be required if you subscribe to both Internet service and
IPTV service. If your ISP did not provide you with a VLAN ID, leave the Use
VLANID check box cleared, which is the default setting.
For information about setting up VLAN tag groups, see Set Up a Bridge for
a VLAN Tag Group on page 198.
Priority (802.1p)
If your ISP provided you with a VLAN ID and a priority value, enter the
priority value, which is a number from 0 to7.
You can enter a priority value only in combination with a VLAN ID. If your
ISP did not provide you with a priority value, leave the default setting (0).
Bridge Mode (bind LAN4 to
WAN2)
This setting is an option that applies to the IPTV interface only. To bind LAN
port 4 to the IPTV interface (that is, the WAN2 virtual interface), select the
Bridge Mode (bind LAN4 to WAN2) check box.
For more information, see Enable Bridge Mode for an IPTV Device on
page 200.
Account Name (If Required)
Enter the account name, as indicated by your ISP. This name might also be
called the host name.
If your ISP did not provide you with an account name or host name, leave
this field blank.
Domain Name (If Required)
Enter the domain name, as indicated by your ISP.
If your ISP did not provide you with a domain name, leave this field blank.
Internet IP Address
Get Dynamically from ISP
Your ISP uses DHCP to assign your IP address. Your ISP automatically
assigns these addresses.
Use Static IP Address
Enter the IP address, IP subnet mask, and gateway IP address that your
ISP assigned you for static IP address service. The gateway is the ISP
router to which your modem router connects.
Use IP over ATM (IPoA)
Enter the IP address, IP subnet mask, and gateway IP address that your
ISP assigned you for IPoA service. The gateway is the ISP router to which
your modem router connects.
Manage the Internet Settings Manually
69