Download Sensistor ISH2000
Transcript
C 201 Change test mode Choose the measuring method you will use in the menu Change Test Mode. There are three different methods to choose: • Analysis Mode • Detection Mode • Combined Mode Figure C-4: Change test mode screen example Calibration The instrument must be calibrated by using the integral calibration function to ensure it displays the correct values in Analysis Mode/Combined Mode. After calibration the instrument will show the correct measured values on the display. The calibration parameters will be stored into the probe. Figure C-5: Calibration screen example Detection mode settings In Detection Mode, the signal is displayed in the form of a bar. The length of the bar varies with the gas concentration. Figure C-6: Detection mode screen example Analysis mode settings In Analysis Mode the measured value is displayed in figures. The default unit is in PPM but it is possible to choose other units, See .“C 500 Factory configuration of the leak detector parameters” on page 65 Figure C-7: Analysis mode screen example Sensistor ISH2000 Technical Reference Manual (TRM) EN- 50