Download Instruction Manual

OBJ_BUCH-1128-002.book Page 49 Tuesday, July 13, 2010 11:27 AM
English | 49
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
In addition, the cut can be perfomed with or
without slide movement depending on the
width of the profile strip/moulding.
Always make trial cuts with the mitre angle setting first on scrap wood.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Placed
against
the fence
Vertical bevel angle
Lying flat
on the
saw table
0°
45°
Floor strip/moulding
Left side
Right side
Left side
Right side
Inner corner Horizontal mitre
angle
45° left
45° right
0°
0°
Bottom edge
on saw table
Bottom edge
on saw table
Upper edge
against the
fence
Bottom edge
against the
fence
The finished
workpiece is located...
... to the left of
the cut
... to the right
of the cut
... to the left of
the cut
... to the left of
the cut
Horizontal mitre
angle
45° right
45° left
0°
0°
Positioning of
workpiece
Bottom edge
on saw table
Bottom edge
on saw table
Bottom edge
against the
fence
Upper edge
against the
fence
The finished
workpiece is located...
... to the right
of the cut
... to the left of
the cut
... to the right
of the cut
... to the right
of the cut
Positioning of
workpiece
Outer
corner
Bosch Power Tools
1 609 929 X04 | (13/7/10)