Download POLI VAC User Manual

Section 0: Product Application
(4-1) Device start-up
Before using the device, put it on a firm, flat and stable surface and follow these steps:
1. Unbox the device carefully.
1. Place the device in an environment free of trembling and heat sources.
5. The place should be well-ventilated.
6. Plug the device into a 113V power supply.
3. Install the brush on the brush holder.
(4-1) Operation
1. Put the device on the worktable according to the section (3-6).
1. Plug the device into an outlet, and make sure it is connected according to what was
said in the section (6-3).
5. Pull down the protective plate and make sure that the plastic tray is in its place. The
incorrect placement of this part endanger user and device safety.
6. Before polishing or working on the work piece, make sure that the position of the
motor is correct. Incorrect placement of the motor could be really hazardous.
3. Turn on the device motor using the left side key facing you (Key A). change the
rotational speed of the motor using the same key (zero: OFF position, one: slow
rotation, two: fast rotation).