Download IP65 LED Wall Washer W-010 User Manual

160-167
R 100%
G75%
B100%
168-175
R 100%
G 100%
B 100%
176-183
R 100%
G 100%
B 25%
184-191
R 100%
G 100%
B 50%
192-199
R 100%
G 100%
B 75%
This device has left the factory in perfect condition. In order to maintain this condition
200-207
R 100%
G 100%
B 100%
and to ensure a safe operation, it is absolutely necessary for the user to follow the
208-215
R 20%
G 100%
B 100%
safety instructions and warning notes written in this user manual.
216-223
R 40%
G 100%
B 100%
224-231
R 60%
G 100%
B 100%
232-239
R 80%
G 100%
B 100%
If the device has been exposed to temperature changes due to environmental
240-247
R 20%
G 100%
B 100%
changes, do not switch it on immediately. The arising condensation could damage
248-255
R 50%
G 50%
B 50%
the device. Leave the device switched off until it has reached room temperature.
8. Technical Specifications
2. Safety Instructions
This device falls under protection-class I. Therefore it is essential that the device be
Input Voltage: AC 90-260V/50-60HZ
earthed.
LED Quantities: 16 red/ 16 green/ 16 blue (3W)
The electric connection must carry out by qualified person.
Control Signal: DMX512
The device shall only be used with rate voltage and frequency.
Control Channel: 8CH
Make sure that the available voltage is not higher than stated at the end of this
Power Consumption: 144W
manual.
Gross Weight: 9kg
Make sure the power cord is never crimped or damaged by sharp edges. If this would
Shipping Dimension: 530*230*200mm
be the case, replacement of the cable must be done by an authorized dealer.
9. Key Features
48*3W red, green and blue LEDs
Colors optional for customers, single color or RGB
LED RGB technology with 256 degree gray scale function
Synchronous effect through intelligent controller
DMX controller controllable
8 DMX channels
Digital IP address together with built-in fixed program for synchronization and self-link
Light angle and position adjustable for optimal lighting effect
Applicable for both indoor and outdoor like stage, bar, nightclub,
courtyard, architectural, theme park, etc. (Protection rating: IP 56)
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power cord by the plug. Never pull out the plug by tugging the power
cord.
During initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm
distance with wall for smooth air flow, so there should be no shelter for fans and
ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.