Download AutoPILOT PRO
Transcript
Functional Description Flow Computer Tasks Caution The water content equation used for the full calculation method is not an AGA sanctioned equation. Care should be taken in custody transfer applications. For custody transfer applications, the manual or partial calculation methods should be used using lab results or AGA test methods for determining water vapor content. ▲ Fws A full well stream factor is provided for production applications that require compensation for well stream conditions. This value defaults to 1.0 and is a direct multiplier into the flow rate equation. Turbine Meter Linearization A 10-point break-pair table of K-Factor versus Frequency is utilized for the linearization of turbine meter K Factors. Individual tables are used for each meter run configured as a linear meter. Interpolation of the K-Factor between table points may be enabled and disabled on an individual meter run basis. Averaging Techniques Users may configure the AutoPILOT PRO flow computer to support one of the four averaging techniques as outlined in the API Ch 21.1. 1. Flow dependent time-weighted linear averaging 2. Flow dependent time-weighted formulaic averaging 3. Flow weighted linear averaging 4. Flow weighted formulaic averaging For differential type meters, the square root of the measured differential pressure is used as the weight value in averaging techniques 3 and 4. For linear type meters, the Actual Flow Delta Volume is used as the weight value. Calibration/As Found/As Left A calibration routine is used for all analog inputs. The unit is capable of 2or 3-point calibrations as well as a single point for re-zero. All calibration changes are logged in the audit trail with the old and new values for each of the calibration points. The unit also allows for the verification of all analog inputs through an As Found / As Left procedure as outlined in the API Ch 21.1. Separate audit codes are used for As Found versus As Left audits. Thermo Fisher Scientific AutoPILOT PRO Flow Computer User Guide 10-3