Download K-BUS R Room Controller User manual
Transcript
1 0: As soon as a telegram value 0 is received, heating is activated and cooling is deactivated. 1: As soon as a telegram value 1 is received, heating is activated and cooling is deactivated. 5.6.1.3 2 Control value/2-pipe The 2-pipe system has two control objects act on the heating valve; the cooling valve is not used. Parameter “Toggle automatically, Valve COOL not usable” The parameter serves as a remark that between the heating and the cooling can be toggled via automatically, and the valve COOLING is not usable. The communication objects in conjunction with the cooling valve, e.g. status, forced operation or valve purge are not effective. Valve HEATING/ COOLING Via the communication object ―HVAC-General HEAT‖ or ―HVAC-General COOL‖ the heating valve and the fan can be controlled. Toggling between heating and cooling is implemented by updating the control values. The control values is updated via the object―HVAC-General HEAT‖ or ―HVAC-General COOL‖. I.e. the switch over between heating/cooling should occur exclusively with the respective thermostat. Here only heating or cooling are active, dependent on the last active received control value. When the object ―HVAC-General HEAT‖ or ―HVAC-General COOL‖receives a control value, the monitoring time is re-started. After bus voltage recovery if the heating and the cooling is toggled, the fault is also reset instead of maintain. In the case of the valve control mode―Continuous, PWM‖, output S is effective. In the case of the valve control mode ―3 point, open and close‖, output R is used to close the valve (100%→0%), output S is used to open the valve (0%→100%). Parameter “Operation HEAT/COOL after bus recovery” With the parameter, the reaction after bus voltage recovery is set. Options: Unchanged HEAT COOL Unchanged: After bus voltage recovery, the state that existed before bus voltage failure is re-established. HEAT: After bus voltage recovery, the heating state is set. 103