Download Mac TaskPlusTM ET1205ANX

NOTICE
If the Tool will not be used for an extended period of
time, remove the batteries to prevent battery leakage
from damaging the battery compartment.
Vehicle Power
When the Tool is connected to the vehicle DLC, the Tool is powered
by the vehicle and will automatically turn on once connected.
USB Power
When the Tool is connected to a Personal Computer (PC) via the
USB cable, the Tool will automatically power up.
Connect the Tool
To connect the Tool to the vehicle:
1. Locate the OBD II connector under the
steering column.
If the connector is not there, a label
should be there indicating the whereabouts of the connector. For more information on OBD II connectors, go to http://
www.obdclearinghouse.com/oemdb.
2. If necessary, remove the cover from the vehicle
connector.
3. Turn the ignition switch to the ON position. Do not start the
engine.
4. Plug the OBD II connector attached to the Tool into the vehicle
connector.
The Tool automatically reads codes and I/M monitors and displays
the data. When done viewing data, press  BACK key to return to
Diagnostic Menu.
Diagnostic Menu User
Interface
Diagnostic Menu
=========================
I/M Monitors
Read Codes
Erase Codes
MIL Status

State OBD Check
View Data
To select functions:
1. From the Diagnostic Menu,
press the UP or DOWN
arrow key until the desired
function is highlighted, then
press the
ENTER key to
8