Download "user manual"

Transcript
emitting again each time . Hold down the "Laser" button, the laser tube lights
emitting up to a light in 0.5 seconds.This key is valid only in a wait or pausestate of
the system in ; other state invalid
Speed: Set the cutting speed, 0% -100% optional . This key is valid
in wait or pause , others are invalid. Speed 100% is Limiting speed according to
machine parameter
Mini power: set the minimum power, optional 0% -100%. This key
is valid in wait or pause, the other states are invalid.
Maxi light intensity: set the maximum light intensity, optional 0%
-100%. This key is valid in wait or pause, the other states are invalid.
Files: view and the operator panel to load a file that runs
Start / Pause: During work and pause, switch the system state. When
the system is in working condition, press this key, the system enters the suspend
state;if the button is pressed again, the system goes back to work. This key is valid
in work or suspend state, other states are invalid.
Origin: This key is used to define (change) cutting origin. Before to
modify the cutting origin, please move the laser head to the cutting starting
oposition using arrow keys:
1, Short press this key to determine the laser head location for cutting the
origin;
2, if the long click the button for above 3 seconds to determine the cutting
origin, and the system self-test, draw a self-test graphics.
3, This key is valid in waitting condition, other state invalid.
Frame: border line motion of the laser head
46-24