Download SPRINTER & TRIKE

Sprinter& Trike User Manual
Operating the forklift truck
Note ! In the case of the Prins Trike the ballast plates are located below
the rear engine cover, both on the left and right. The ballast weights must
always be added or removed in pairs, one from the left and one from the
right. The weight of a pair of Trike weights is equivalent to the weight of a
single Sprinter weight. See Table 5.12. In case of doubt, ALWAYS fit the
full number of ballast plates to the fork lift truck and secure these.
5.8 Use of the tow hook (Prins Sprinter only)
The Sprinter is equipped as standard with a tow hook to allow other vehicles to be towed.
Ensure in all cases that the vehicle to be towed can be towed safely. Always ensure that the
securing pin is properly installed
Note! Ensure that the tow hook securing pin is properly installed at
all times! A towed vehicle which comes loose may cause injury
and/or damage.
The maximal load on the tow hook is 500kg. If the hook is loaded beyond this there is a risk of
it breaking, which may result in damage to the vehicle.
20
Prins Maasdijk,
Jan-12