Download STC-DAIKIN A/C - REM

3. Configuration
The STC-DAIKIN A/C (Figure 3.1) has two switches, a button and a profile selector to
execute the Learning and Teach-in procedures from the EnOcean technology (explained in
Table 3.1 and the following sections)
CON1
LEDO
PB1: Button
LEDM
1
MOD1: EnOcean module
enocean ®
<- TEACH / LEARN ->
<- NORMAL / ERASE ->
ROT1: Profile selector
ON
2
SWITCH1: switches
- 1 SW1-1
- 2 SW1-2
0 1
EF
2
D
3
C
4
B
5
A
6
9 8 7
PB1
ROT1
PROFILES
MOD1
SWITCH1
(SW1)
CON1: AC connector
LEDM: AC LED
Intesis software
IS1-AC-ENO-1-v11-REV0
Antenna
LEDO: EnOcean LED
Figure 3.1 Device diagram
The switches in SW1 configure the behavior of the interface. The different working modes
are explained in Table 3.1.
Mode
Normal
operation
Teach-in
Switch 1
(SW1-1)
Off
Switch 2
(SW1-2)
Off
EnOcean LED
state
Off
Off
On
Off
On
On
Off
On
On
Flashing:
100 ms On /
100 ms Off
/
EnOcean
transmission
disabled. Only
allows Teach-in
Learning
Erase
Button PB1 function
Send a Teach-in telegram
or activate monitor mode
(pressing it during 5
seconds)
Send a Teach-in telegram
or activate monitor mode
(pressing it during 5
seconds)
No function
Delete the devices in the
selected profile (pressing
it during 5 seconds)
Table 3.1 Interface working modes.
Selector ROT1 it is used to select the desired profile. The transmission profile is used when
the device is in Teach-in mode and the reception one when in Learning or erase mode.
Thermokon Sensortechnik GmbH - Aarstrasse 6 - 35756 Mittenaar - Tel.: 02772/65010 - Fax: 02772/6501400 - www.thermokon.de - [email protected]
produktblatt_stc_daikin_ac_eng
©2011
Page 9 of 30