Download Forecaster user manual

Forecaster v2.0
Regimes
Drag and Drop
A row or cell individual can be copied or moved using Drag and Drop. This may be useful when
the order of events within a command, or when the order of commands themselves, needs to
be changed.
An item can be moved by placing the mouse pointer over the item, then dragging and dropping
it on the destination location. The mouse pointer will change to indicate that a drag operation
is in progress. If the item(s) being dragged may be dropped onto the item under the mouse
pointer, then it will be highlighted, or a separator will be displayed to indicate either where
the item being dragged will be inserted, or which item will be overwritten. If the item(s) being
dragged may not be dropped on the item under the mouse pointer, then the mouse pointer
will change into the “ ” symbol.
Note that when dragging and dropping an event, it will be inserted either before or after the
event onto which it is dropped. A red line indicates the position at which the event will be
inserted. An arrowhead in the middle of the line indicates which command the event will
belong to when it is dropped. For example, in the screenshot below, a Thin to Waste event is
being dragged. If it is dropped, it will be inserted into the same command as the first prune
event, and after that event. This is indicated by the upwards-pointing arrowhead:
© 2014 New Zealand Forest Research Institute Limited
105