1
Download PTP 800 Licensed Ethernet Microwave User Guide
Transcript
Installing the CMU Chapter 5 Installation Connecting the CMU to the IF cable Cut any surplus length from the CMU end of the LPU-CMU IF cable and fit an N type connector, as described in Fitting an N type connector to an IF cable on page 5-39. NOTE For a protected link with an asymmetric coupler, ensure that the following connections are made: 5-78 o The IF cable from the ‘MAIN’ side of the ODU coupler is connected to the CMU labelled ‘Primary’. o The IF cable from the ‘STANDBY’ side of the ODU coupler is connected to the CMU labelled ‘Secondary’. phn-1478_012v000 (May 2011)
