Download PTP 800 Licensed Ethernet Microwave User Guide

PTP 800 Licensed Ethernet Microwave User Guide
Managing alarms and events
Alarm
Definition
Likely cause
FCC capacity check
The Transmit Capacity Limit
of the unit (lower of license
key and negotiated Ethernet
speed at remote end) is
below the appropriate level
required by FCC Part
101.141.
This is probably due to a
configuration error or the
wrong license being applied
to one of the CMUs.
Wireless Receives Signal
Status
The Wireless Receive Signal
Status indicates if the
receiver is able to
demodulate the transmit
signal from the remote end
of the link. If it cannot a
protection switch may occur
in a system configured for
1+1 Hot Standby.
This may be due to
hardware problems: the
ODU, the antenna or CMU
see the diagnostic
procedures under Installing
the link on page 8-9.
Licensed Transmit Capacity
Status
In a 1+1 Hot Standby
configuration, this indicates
that the Licensed Transmit
Capacity is below that of its
neighbor.
This is probably due to a
configuration error or the
wrong license being applied
to one of the CMUs.
Data Port Ethernet Speed
Status
In a 1+1 Hot Standby
configuration, this indicates
if the Ethernet Speed of the
Data Port is below that of its
neighbor.
This is probably due to a
configuration error.
Management Port Ethernet
Speed Status
In a 1+1 Hot Standby
configuration, this indicates
if the Ethernet Speed of the
Management Port is below
that of its neighbor.
This is probably due to a
configuration error.
phn-1478_012v000 (May 2011)
It may also be due to
incorrect configuration or
adverse weather conditions.
7-17