Download PROTAX User Manual

Transcript
earlier for training data, each line contains two fields seqid and taxname (textual identifier of taxonomy node). correct_path.pl my_testclas.txt example_taxonomy.txt
example_testseqid2taxname.txt > my_testresults.txt
Summary of the classification can be done in R. > a=read.table(“my_testresults.txt”,header=T)
> summary(a)
In the output, mean of columns levelL.correct is the correct classification rate at level L. The number of times each level was the most specific level of classification (noting that in case of unk-­‐node, the level of the parent node is given) can be obtained by > table(a$level)
Bias-­‐accuracy plot can be investigated by plotting the cumulative probability of the best classification outcome from each test sequence against the cumulative number of the correct classification results. In order to be useful, the input file should contain only the best classification outcome for each sequence. Note that the outcome probability a$prob is only for the most probable leaf node of the taxonomy and the probabilities of its parent nodes are not saved in file ‘my_testresults.txt’. Therefore some care must be taken how to choose against which the outcome probabilities are compared. In this particular example, we can use column a$correct.level2. > accuracy.plot(a$prob, a$correct.level2, name=”my results”)
The plot is a straight line along the diagonal of the display when there is no bias in the output probabilities. In addition to producing only the most probable taxon as a result of classification, it is possible to output multiple taxa. The following outputs 2 best taxa for each test sequence (in this example we set the probability threshold equal to zero) classify_seqsimfile.pl example_testseqids.txt example_taxonomy.txt
example_trainseqid2taxname.txt my_rseqs.txt my_mcmc.txt map
example_testseqsim.txt 2 0.0 my_testclas2.txt 0 1
Again, the most informative way to investigate the results is to add the taxon name add_taxonomy_info.pl example_taxonomy.txt my_testclas2.txt >
my_testclas2name.txt
Step 4. Getting node probabilities for each taxonomy level The previous PROTAX classification lists only leaf nodes as an outcome. In order to investigate node probabilities in different levels of taxonomy, we can use another program. The input is similar as in the previous step, but now the maximum number of outcomes to be outputted is 15