Download USER`S MANUAL

OPERATION SUMMARY
OPERATION
ARM
The panel must be in
a Disarmed state first.*
LCD KEYPAD
LED KEYPAD
or...
[User Code]
ARM
[User Code]
DISARM
(Arming Shortcut
must be ON, P62E 5E)
ENTER
ARM
ENTER
RADIO KEY
(Arming Shortcut
must be ON, P62E 5E)
or...
[User Code]
[User Code]
ENTER
To Disarm and/or reset
alarms.
MONITOR MODE
The panel must be in
a Disarmed state first.
or...
PANIC
or...
PANIC
or...
PANIC
x2
x2
or...
Both keys together
[User Code]
ENTER
ENTER
(Keypad Panic Shortcut
must be ON, P62E 4E)
ENTER
[User Code]
Press OFF button twice within 4 seconds
or ON button twice within 4 seconds
P69E 5E must be ON
Both keys together
or...
or...
[User Code]
(Keypad Panic Shortcut
must be ON, P62E 4E)
Hold
Press and hold for 4 seconds
(P68E 3E & 4E must be OFF)
[5, 6, 8 or 9] [User Code]
To Disarm and report a Duress Alarm, add any of the digits 5, 6, 8 or 9 before the
User Code when Disarming. P75E1E must be enabled
ENTER
EXCLUDE
or...
[User Code]
EXCLUDE
[Zone No.]
[Zone No.]
ENTER
ENTER
ENTER
VIEW MEMORY
View Memory can only be
used when the panel is
disarmed.
PANIC
ENTER
[5, 6, 8 or 9] [User Code]
EXCLUDING ZONES
EXCLUDE + CODE + ENTER
can be used when the panel
is armed or disarmed.
[User Code]
MONITOR
Keypad Duress is factory
defaulted for silent reporting
EXCLUDE + ENTER can only
be used when the panel is
disarmed.
(Monitor Shortcut
must be ON, P62E 3E)
or
PANIC
KEYPAD DURESS
(Monitor Shortcut
must be ON, P62E 3E)
ENTER
MONITOR
or...
Press
[User Code]
MEMORY
MEMORY
ENTER
(Exclude Shortcut
must be ON, P62E 2E)
ENTER
or...
Enter the zone numbers
to be Excluded
[Zone No.]
[Zone No.]
(Memory Shortcut
must be ON, P62E 1E)
ENTER
repeatedly to display the last
30 events
To exit Memory mode
[User Code]
Enter the zone numbers
to be Excluded
To exit Exclude mode
To exit Exclude mode
ENTER
MEMORY
(Exclude Shortcut
must be ON, P62E 2E)
(Memory Shortcut
must be ON, P62E 1E)
or...
Press
[User Code]
repeatedly to display
the last 30 events
To exit Memory mode
* NOTE: Normal user codes can arm the panel only if it is fully disarmed first.
User codes that are programmed to be Arm Only codes can arm the panel from Monitor mode or from the disarmed state.
28
NESS D8 V4.5 CONTROL PANEL - USER MANUAL