Download OFS-920 - Precision Rated Optics

OFS-920
3) Insert the wrench bolt into the cam pin and pull it with tweezers and detach the slider.
4) Be careful not to damage the blade. Assemble the part in the reverse manner. Tighten the set-screw
firmly.
Adjustment of blade height
1) Insert a wrench into the hole at the bottom of the cleaver and loosen the set screw of the slider a little bit
(about 2 turns). At this point, the slider has to be moved backward.
2) Adjust the blade height by turning Cam Pin with a flat-head screwdriver.
Clockwise turning: going upward
Counter clock wise turning: going downward
3) When the blade reaches required position, tighten the set-screw of the slider. Thoroughly and accurately
set the height using a gauge because the height directly effects the cleave quality of fiber.
www.PrecisionRatedOptics.com | 888-545-1254
33