Download Ferris Wheel Positioner

Transcript
Every 20,000 Hours of Operation
Gearboxes
A servo driven gearbox is located at the head of each minor axis. Every
20,000 hours of run time, change the grease in each gearbox. To change
the grease:
1. Remove the tool.
2. Rotate the axis for about 15 minutes to warm up the grease
and make it flow more easily.
3. Each gearbox has two plugs. Locations vary depending on
the gearbox. It may be that both plugs are on the front side,
or one plug is on the front and one on the back. Locate the
plugs. Make sure the axis is positioned so that the two plugs
are aligned vertically. Remove the plugs.
4. Siphon the grease from the lower hole into an acceptable
container. Use CAUTION – grease may be HOT!
5. Pump grease into the lower hole so that the grease works its
way up into the gears. Refer to the Gearbox Lubrication
Quantities chart to determine the type and quantity of
lubrication.
6. Replace plugs.
Horizontal
Vertical
Center shaft
NOTE: Horizontal/vertical refers to the orientation of the center shaft.
26