Download warning - Fujitsu

USING SETUP MODE
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options
<CNT-LD>
Selection for the paper feeding of
continuous forms paper
PRCISIN
Gives a higher priority to precision.
SPEED
Gives a higher priority to speed.
<CSF-LD>
Selection of the method of feeding
from the CSF
NORMAL
Feeds paper directly from the CSF
hopper.
SWBACK
Feeds paper from the CSF hopper to
either the cut sheet table used with a
front CSF or the stacker used with a
rear CSF. Then, that paper is fed
again.
<CSFAPTC>
Paper thickness detection with use of
a CSF
ALWAYS
Every sheet of paper that is fed
NORMAL
Sheet of paper that is fed immediately
after the feed pin is switched
<LF-CTL>
Selection for LF mode
PRCISIN
Gives a higher priority to precision.
SPEED
Gives a higher priority to speed.
<PR-MODE>
Selection for print mode
(standard/low noise)
NORMAL
Prints in standard mode.
QUIET
Prints in low-noise mode.
<HI-IMPT>
User's Manual
Description
Selection for high printing pressure
mode
DISABLE
Prints in standard pressure mode.
ENABLE
Prints in high printing pressure mode.
5-49