Download Stoneridge

5.
Select TIME/DATE from the main menu and
press ENTER.
SE5000 MAIN MENU
:TIME/DATE
Current time - Press ENTER and a cursor will
flash. Key in the current time and press
ENTER.
Current time
:10:35
Current date - Press ENTER and a cursor will
flash. Key in the current date and press
ENTER.
Current date
:19/10/2003
Time offset - Press ENTER and use the
up/down arrow keys to choose a time offset
between +23:00 and –23:00 hours and +59
and –59 minutes.
Time offset
:+1: +00
Press the Send key to send the data to the
tachograph.
Sending data
PROGRAMMING A TACHOGRAPH
The method of programming a tachograph varies according to the type of tachograph. For earlier
types of electronic tachograph, programming is generally carried out using internal DIL switches.
Later types require an external Programmer to set some or all of the required parameters.
Of the types requiring an external Programmer, the MKII Tachograph Programmer supports
programming of the Stoneridge VR8400/2400/SE5000 series, Kienzle 1319/1324/DTCO series,
MotoMeter EGK-100 and Actia Smartach tachographs.
Note that in all cases the instructions suggest that, once settings have been altered, the SEND
ALL DATA (shortcut key 9) command be used to transfer all the information at the end. It is,
however, possible to send each individual setting after alteration by pressing the SEND key
(except Kienzle 1319, EGK-100 and Smartach).
5.1
Programming Stoneridge VR8400 Series tachographs
Parameters which may be programmed
•
Pulses Per engine Revolution (PPR) setting
•
Ignition-on recording
•
Low power Band
•
Overspeed
•
Economy band
•
Poor Economy
Connections
Table 11: VR8400 series Programming connections
38
Document No. 6957-193
June 2006 Revision 2.3
©Copyright Stoneridge Electronics Ltd
Manufacturers of VEEDER-ROOT Tachographs