Download Real-Time Software User`s Manual

Chapter 2:GUI Reference
LLT Loop Push Button. Open/Close the LLT M3 control loop.
2.1.5 MAIN>Operation>DM Window
2.1.5.1 MAIN>DM>Voltages Tab
ROT FLAT. Load and apply the voltages stored in the file flattendm.cfg including a correction
factor based on the current rotator angle.
STATIC FLAT. Load and apply the voltages stored in the file flattendm.cfg to the DM.
REC FLAT. Save the currently applied DM voltages to disk using the protected name
flattendm.cfg and flattendm-YYYYMMDDTHHMMSS.cfg.
Load Voltages. Load predefined sets of voltages from disk to the Loaded voltages column in
the Voltages Table.
Save Voltages. Save the currently applied DM voltages to disk.
Reset To Value. Set Loaded voltages column in the Voltages Table to a user defined value.
Value. User defined voltage.
Apply Voltages. Write Loaded voltages to the DM.
delay. Send voltages to DM with a delay of 1 second.
Voltages Table. Table displaying voltage data updated once a second. Each row corresponds to
an actuator. Double click a row to open a pop-up window and load a new voltage value.
2.1.5.2 MAIN>DM>Graph Tab
The Graphs tab presents a typebar graph showing the voltage applied to each electrode. The values
are normalized [1,1]. This typebar representation is useful to detect saturation.
2.2 MAIN>Historical Tab
From this pane it is possible to examine the last five system faults and to check the faults chart.
Last Faults. Last five faults encountered by the application.
Faults. List with all the defined fault conditions and their current state. See the section 4.1.12
below for customizing this list.
REFRESH. Allows the user to update the faults list on demand.
2.3 MAIN>Maintenance Tab
The Maintenance tab is only accessible after entering maintenance mode. From this pane it is
possible to route direct commands to several software/hardware RTC modules and to have access to
some low level functionality.
13
Rtsoft User Manual Rev 1.10, January 2013