Download ID Pro - Key Logic

88 KeyLogic ID Pro Reflasher 89 KeyLogic ID Pro Reflasher Procedure #2 Procedure #3 Toyota 4Runner Camry V6 Landcruiser Sienna 2003‐2004 2003 2003‐2004 2004 Lexus GX470 LS430 LX470 SC430 Toyota Camry Corolla FJ Cruiser Prius Sequoia Solara 2003‐2004
2001‐2003
2003‐2004
2002‐2003
To register keys into a new/virginized ECU: 1.
2.
3.
4.
5.
6.
7.
8.
Security light should be on, indicating that the immobilizer is in Auto Learn Mode. Insert a key into the ignition (do not turn). The security light should blink once and then remain solid, indicating the key has been registered. Remove key from the ignition. Repeat step #2 3 more times. Removing the 4th key closes auto learn mode. The first 3 keys are registered as MASTER keys, the last key becomes the VALET key. Once Auto Learn Mode has been closed, the immobilizer must be resynchronized with the ECU before the car will start. Insert a MASTER key into the ignition switch and turn to the ON position (do not crank the vehicle!). Insert the Toyota/Lexus OBD2 Resync Tool (shorts terminal 4 and 13) and start a timer for 30 minutes. Once 30 minutes has passed, remove the Resync Tool. Turn ignition switch off and remove key. Reinsert key and confirm that the vehicle can now be started. 
Security light blinking two long blinks followed by one short blink indicates that Auto Learn Mode failed. Security light blinking two short blinks followed by two long blinks indicates that a key that had already been registered was reregistered a second time. To register keys into a new/virginized immobilizer: 1.
2.
Ensure there is no key in the ignition. While sitting in driver’s seat, close all vehicle doors but do not lock them. 3. Insert first master key into the ignition switch (do not turn) and wait 5 seconds. 4. Remove key and insert second master key into the ignition switch (do not turn) and wait 5 seconds. 5. Remove key and insert a valet key into the ignition (do not turn) and wait 5 seconds. 6. Remove key. 7. Once Auto Learn Mode has been closed, the immobilizer must be resynchronized with the ECU before the car will start. Insert a MASTER key into the ignition switch and turn to the ON position (do not crank the vehicle!). 8. Insert the Toyota/Lexus OBD2 Resync Tool (shorts terminal 4 and 13) and start a timer for 30 minutes. 9. Once 30 minutes has passed, remove the Resync Tool. 10. Turn ignition switch off and remove key. 11. Reinsert key and confirm that the vehicle can now be started. Tip: If you would like to program less than 4 keys, Auto Learn Mode must be closed manually: turn ignition switch on and then off 5 times within 10 seconds, then remove the key from the ignition. 
2004
2004
2004
Note: Up to 4 keys may be registered. Troubleshooting: Lexus
ES330
LS430
RX330
2001‐2004
2005‐2010
2010‐2012
2001‐2003
2003+
2003‐2004
Tip: If you would like to program less than 3 keys, Auto Learn Mode must be closed manually: turn ignition switch on and then off 5 times within 10 seconds, then remove the key from the ignition.