Download GV-Video Server

4 Administrator Mode
4.3.7 Video Gateway
Note the function is only available on GV-VS02A (Firmware Version 1.01 or later), GVVS04A and GV-VS12 (Firmware Version 1.02 or later).
To send the video images to the Video Gateway, follow the steps below.
Figure 4-24
1. Activate Link: Enable the connection to the Video Gateway.
2. Host Name or IP Address: Type the host name or IP address of the Video Gateway.
3. Port Number: Match the communication port on the Video Gateway. Or keep the
default value 50000.
4. User Name: Type a valid user name to log into the Video Gateway.
5. Password: Type a valid password to log into the Video Gateway.
6. Cease motion detection messages from: Stop sending the videos of motion
detection from the selected camera.
7. Enable schedule mode: Enable the Video Gateway connection on the schedule you
set in the Select Schedule Time section. Refer to 4.5 Recording Schedule for the
same settings.
8. Click Apply. The Connection Status should display “Connected” and connected time.
63