Download Platework User Manual

Page
1-14
Date
01-JUN-1991
Version number
1.0
CHANGE LOAD-ON-CAPACITY-MODEL
COMMAND:
CHANGE LOAD-ON-CAPACITY-MODEL  AUTOMATIC ...
 MANUAL ...
PURPOSE:
To modify basic Capacity Model loads previously created by use of the CREATE LOAD-ON-CAPACITYMODEL command.
SUBCOMMANDS:
AUTOMATIC
Automatic re-calculation of reduced Capacity Model loads from the unreduced loads
MANUAL
Manual re-definition of reduced Capacity Model loads.
NOTES:
1
Results will be deleted
Any previously calculated Code Check results for the referenced combination of Capacity Models and resultcases will be deleted on the successful completion of this command.
See also:
CREATE LOAD-ON-CAPACITY-MODEL
CREATE RESULTCASE
CHANGE RESULTCASE
READ SIN-DIRECT-ACCESS
CHANGE CAPACITY-MODEL