Download Tycho GPS Frequency Reference User Manual
Transcript
"Smarter Timing Solutions" AppendixB Upgrading the Firmware Periodically, EndRun Technologies will make bug fixes and enhancements to our products available for download from our website. All such downloads are freely available to our customers, without charge. After you have downloaded the appropriate FLASH binary image file from the EndRun Technologies website, you are ready to perform the upgrade to your Tycho. The firmware consists of two FLASH binary image files. One of these is the firmware for the Tycho itself. This firmware executes on the IBM-compatible CPU and contains the embedded Linux operating system. The other file is the firmware for the GPS time and frequency subsystem. Each of these files may be upgraded independently, although some upgrades require both images to be modified together. What You Need To Perform the Upgrade Performing the Linux Upgrade You will need to use ftp or scp to transfer the binary image file(s) to the Tycho. This means that you must place the previously downloaded file(s) in a place on your network which is accessible to the Tycho. There are two FLASH disk partitions which hold the compressed Linux root file system images. These partitions are raw FLASH blocks, have no file system and may not be mounted. They are accessed through low-level devices. To protect the factory root file system from accidental erasure or over-writing, the device node has been deleted. The upgrade FLASH disk partition is accessed via /dev/rootfs_1. When performing an upgrade, you will be copying the new image to this device. CAUTION Some browsers will automatically unzip the gzip file when downloading from the website. Please make sure that the gzip file is less than 6M in size before proceeding. Upgrading the partition with a too-large file size can cause serious problems and the unit may have to be returned to the factory for re-programming. To perform the upgrade, log in as the root user to the Tycho using the local console serial I/O port, telnet or ssh and perform these operations: First erase the upgrade partition by issuing this command at the shell prompt: eraserootfs_1 39 Ty c h o G P S U s e r M a n u a l