1
Download - Simtek Electronic Performance
Transcript
Rev Limit Coolant Rev Limit Cold Rev Limit Cold Abs Option ˚C Option rpm Option If coolant lower than Rev Limit coolant, Rev Limit = Rev Limit Cold, ignored if 0. If on and Coolant less than Rev Limit Coolant then the fuel and ignition limiters are set to Rev Limit Cold, else the limit is the warm limit plus Rev Limit Cold Idle Dead Band Option rpm Idle Set Rate MAF source MAF min MAF max Option mS Option Option Option The minimum deviation above Idle Target to provoke a change in Idle feedback. Update rate for Idle speed feedback system, typically 150mS. Err Mask MAP Err Mask Air Err Mask Coolant Err Mask Baro Err Mask Crank Err Mask Lambda#1 Err Mask EE checksum Err Mask Inject dty Err Mask Knock Err Mask Lambda#2 Err Mask MAF Err Mask IO Err Mask Rom Err Mask Flash Option Option Option Option Option Option Option Option Option Option Option Option Option Option Fuel Pump Pin Option Output pin selector. OX FB I const Table Selects oxygen feedback integrator dependant on engine speed. Lambda Lambda 2nd Table Table Tacho pin Option Air Temp min Air Temp max Air Default Option ˚C Option ˚C Option ˚C If the scaled temperature falls outside the normal min to max range then the Error AIT signalled and the default used as the working value. Plenum min Plenum max Plenum Default Option ˚C Option ˚C Option ˚C If the scaled temperature falls outside the normal min to max range then the Error Plenum T signalled and the default used as the working value. AIT Temp min AIT Temp max AIT Default Option ˚C Option ˚C Option ˚C If the scaled temperature falls outside the normal min to max range then the Error Air Temp signalled and the default used as the working value. Coolant min Option ˚C (AFR) Scales raw oxygen 1 signal. (AFR) Scales raw oxygen 2 signal. SimTek FIRMWARE USER MANUAL page 57
