Download - Simtek Electronic Performance

Purge Output Pin
Option
Rad Spray Cool
Rad Spray AIT
Rad Spray ALS
Rad Spray on
Rad Spray off
Rad Spray Load
Option
Option
Option
Option
Option
Option
Accel rtd
Option ˚
Accel R Dk
Output Selector for carbon canister purge
function.
˚C
˚C
If both temperatures and load exceeded then
the radiator spay active
Active only in Full anti-lag mode
Sec
Active on duty time
Sec
Inactive off duty time
(Load) Minimum load
˚
A/C request Hex Mask
A/C request bit Mask
A/C request source
Option
A/C request Bigend
A/C in pin
Option
Option
A/C Off Pedal
A/C#1 Pin
A/C#2 Pin
A/C#3 Pin
A/C out delay
Option
Option
Option
Option
Option
EGT Rtd limit
Table
EGT source
EGT bigend
EGT raw min
EGT raw max
EGT default
Option
Option
Option
Option
Option ˚C
EGT
Table
Oil Temp source
Option
Oil Temp bigend
Oil Temp table
Option
Table
Fuel Temp source
Option
Fuel Temp bigend
Option
Option
If accel trigger exceeded then retard ignition
by this many degrees.
After Accel retard event return spark
advance to normal at this rate per rev.
Selects a bit in A/C message that must 1 for
air condition to turn on compressor.
Only active if simple switch selector A/C in
pin = 0
Data shown in parameter A/C message
EvoX typically CAN1 RX2 W1 with this
channel set to receive CAN ID = 0x412
EvoX set On for lower Byte
Defines pin for A/C (air conditioning) request
input.
(Pedal) A/C is turned off if Pedal exceeds this value.
Output pin selector
Output pin selector
Output pin selector
Time in Seconds from request to outputs
active
˚
˚C
Maximum permitted ignition after TDC vs.
EGT.
Comm code any suitable parameter
Swap high and low byte
Safe minimum for EGT source raw
Safe maximum for EGT source raw
If EGT source raw is out of bounds default
value
Converts EGT raw into scaled units.
Comm code any suitable parameter for
Oil Temp raw
Swap high and low byte
Accessed by Oil Temp raw to make
Oil Temperature.
Comm code any suitable parameter for
Fuel Temp raw
Swap high and low byte
SimTek FIRMWARE USER MANUAL
page 64