Download - AnestFusor

If you chose Infusion rate in the Infusion item, you must enter the initial rate in the units specified
in the Units item. The infusion rate always refers to the mass of the drug to be infused. The
pump will adjust the infusion rate according to the concentration of the solution.
Pump speed
If you chose Pump speed in the Infusion item, you must enter the initial rate in ml/hr. The mass
of the drug infused will depend on the concentration of the solution.
Note: The type of infusion rate entered in this step only applies to the initial rate. Once the
infusion is in progress, you will be able to specify the rate of infusion in both ways.
Drug Bolus/Infusion mode: Summary
This is the final step of the drug, model and mode wizard. If you would like to change any of the
parameters displayed in the Summary, click Back. Otherwise, click Finish.
SMB-Facultad de Medicina Universidad de Chile. All rights reserved 2002-2010
22