Download USER MANUAL - CNET Content Solutions

SETTING UP YOUR TV
Single Cable Settings
Satellite Settings
User Slot Number
Switch Type
None
LNB Power
On
No.
Satellite
Dish
1
Astra 19.2E
1
0
User Slot Frequency
1284
Password PIN
None
LNB
Verify Slot Frequency
1
2
Done
3
4
y
Transponder : 1/120 (10729) MHz
Dish Type : Fixed
Lower LOF : 9750
Upper LOF : 10600
If the reception testing completes successfully, the
Auto Tuning startup screen will display.
Auto Tuning - Satellite
Done
Scan Type
Quick Scan
Search Option
Free to Air
Press B / b to highlight Done and press OK.
x
Start Scan
If your satellite dish is moveable, the following
Positioning screen will appear.
You can select Search Option from Free to Air or
All.
Positioning
Satellite : ASTRA 23.5°E
Transponder
When choosing the search option All, all channels
(including encrypted ones) of the satellite will be
searched for. If you wish to only search for
unencrypted (free) channels, please select Free to
Air. In this case, the channel scan will be
completed faster.
1/3(5MHz H(R))
Go to 0
Go to Stored Position
Step Size
1
Positioning
W
E
Satellite : ASTRA 19.2°E
Signal Level
0%
Quality
z
The television will start to search for available
DVB-S channels. The progress bar will indicate
the scan status.
Store Position
Press B / b to highlight Positioning, and then
press C / c to find the dish position with the
strongest signal level.
When the search is complete, the Auto Tuning
results screen will display the total number of
services found.
Press B / b to highlight Store Position and press
OK to store the dish position. Repeat steps 23 and
24 for the next satellite as necessary.
Use B / b to move through the list to select a
channel, and then press OK to view.
Adjust the dish position manually for the maximum
Signal Level strength. The signal level strength is
displayed from 0 % to 100 %. A high signal level
can be achieved by adjusting the satellite dish the
best way possible.
Signal Level
Press b to highlight Start Scan, and press OK.
GOOD
PLEASE NOTE
The Quick Setup menu can also be accessed at
any time from the Installation menu.
30%
Press B / b to highlight Done and press OK.
If your satellite dish is not movable, please adjust
the dish manually and press Done.
21
English
If you select Single Cable in step 23, the Single
Cable Settings screen will appear. You can set
the appropriate value for each item and highlight
Done.
LNB allows you to determine the lower and higher
Local Oscillator Frequency (LOF). Usually, the
factory settings do not need to be changed. You
can find the parameters of the lower and higher
LOF on the specification sheet of your LNB.